Be sure to hold the plug when pulling it out do not pull the cord. Be careful not to damage the power supply cord.Protect the unit against excessive heat (e.g.Never use thinner, benzene or alcohol, as these will damage the surface finish. To clean the cabinets and panels when dirty, clean off dirt on the surfaces with a soft, dry cloth.The apparatus should not be exposed to dripping or splashing.When an electrical storm is present, unplug the power cord and disconnect the antenna connections.Any of these could cause an electric shock or a fault. Never open the covers or touch the insides or insert a metal object.This unit contains a muting circuit and it takes about 5 – 6 seconds for this unit to reach stable operation after switching the set to POWER ON mode.To prevent short circuits or damaged wires in the connection cords, always unplug the power cord and disconnect the connection cords between all other audio components when moving the unit.Then, check if the speaker cords are properly connected. If no sound is emitted from the speakers when the POWER is ON, turn down the MASTER VOLUME control and press the POWER button to switch the unit to standby mode.Always set the power to standby mode before connecting and disconnecting connection cords. Check that all connections are proper and that there are no problems with the connection cords.If it is to be left unattended for a long period of time, it is recommended that the unit is switched to standby and the mains plug is removed from the socket. The POWER button on the front panel and remote control switches the unit from ON to STANDBY but does not isolate the unit from the mains supply.We declare under our sole responsibility that this product, to which this declaration relates, is in conformity with the following standards:įollowing the provisions of 73/23/EEC, 89/336/EEC and 93/68/EEC Directive.

Hitachi hta 3000 receiver manual